Now is the time to begin thinking about trimming limbs, branches and brush that might otherwise interfere with a successful deer hunt this fall.

Of course, there’s a right way and a wrong way to do almost anything. So follow these 10 tips for productive and prudent pruning”

Safety first — Trimming elevated vegetation is inherently dangerous. Always wear a safety harness while trimming from an elevated location.

Also wear proper protective clothing including safety glasses, gloves and chaps if trimming with a chainsaw.

And bring a buddy in case there are any emergencies.

Bring the right tools — The vast majority of trimming jobs can be conducted with a quality limb saw and a pair of pruning shears.

Ratcheting shears, a long-handled lopper and a limb saw with a long, telescoping handle can often make things easier. In some cases, a ladder might be required, so use your buddy to steady your ladder while climbing.

A telescoping limb saw makes it easy to safely trim larger, higher branches that block shooting lanes. 

Trim early and often — Most vegetation will be fully developed by mid-summer. But just because you trim now doesn’t mean your hunting sites won’t require some additional attention before hunting begins.

So carry a small, folding limb saw and a pair of pruning shears with you whenever you head to your stands prior to and during hunting season.

Plan your ingress and egress — Consider prevailing winds, and then plan primary and secondary routes to and from each stand or blind location.

Once you identify your routes, clean a trail into your stand sites. You can reduce the odds of bumping deer by taking time to clear your paths of sticks you might step on or noisy brush that may snag you or your gear.

Ameristep offers a handy pruning kit that includes these two key items in a practical belt sheath.

Clear the climb — Remove enough brush at the base of each ladder stand, tree stand or ground blind entrance to remain quiet during entry and exit.

Also trim any branches or twigs that you might brush against and create noise while climbing in or out of your stands.

Clear shooting lanes — Sit in your stand or blind and draw your bow or shoulder your gun in the directions you believe deer are most likely to appear, and then cut any limbs or twigs that might contact you, your gun barrel, arrow or bow — including the small stuff that might get caught between your cam and bow string.

While still in the stand, identify any major limbs that might deflect and arrow or bullet, do your best to eliminate those, as well.

Think seriously about shooting lanes. Our initial thoughts on the places we believe shot opportunities will occur are often dead wrong.

Think about the bucks you’ve observed approaching a field or food plot. Did they stroll up the trail and stop at the very edge? Rarely.

Recall past encounters and you’ll realize that bucks typically stop well short of those defined edges, remaining close to the comfort of thick cover as they scent-check and look for other deer.

Mature bucks also rarely use main deer trails used by does and yearlings, preferring to stay downwind of those primary trails during travel. So look for windows 5 to 10 yards back from field and clearing openings and primary trails, and then clear appropriate shooting lanes.

Don’t over-trim — Cutting brush and limbs in and around your stands and blinds is important, but don’t overdo it. You’ll want to leave some vegetation for concealment, especially around the bottom of the stand and your lower body.

Try to picture what your stand will look like once the trees drop their leaves in the fall, and trim accordingly.  You can always remove more later. 

Prepare ground blind locations — Clear the ground of any sticks, brush or leaf litter that may produce noise once hunting begins.

Keep camera sets clear — Stand sites and shooting lanes are obvious trimming priorities, but don’t neglect your camera sites.

Limbs, grasses or other vegetation within your camera’s field of view can sway in the wind and trigger the shutter, resulting in an annoying abundance of worthless images and reduced battery life.

Don’t leave a noisy mess — Trimmed limbs and twigs shouldn’t be left on the ground, as they might be stepped on and alert deer.  Instead, use them for extra concealment around the lower portion of your stand or around the outside of your blind.